FANUC Series 16/18/160/180-Model C Machining Center Operators Manual

OPERATION
B–62764EN/01
11. SETTING AND DISPLAYING DATA
731
Software operaĆ
tor's panel switch
See subsec. 11.4.10.
Tool offset value
Display of tool
offset value
See III-11.4.1.
OFFSET SETTING WORK (OPRT)
Screen transition triggered by the function key
OFFSET
SETTING
OFFSET
SETTING
OFFSET/SETTING SCREEN
Display of setĆ
ting data
See III-11.4.3
Setting of tool
offset data
See III-11.4.1.
Parameter setting
See III-11.4.3.
Setting of work
origin offset value
See III-11.4.6.
Setting sequence
number comparison
and stop
See III-11.4.4.
Setting the number of parts required
See III-11.4.5.
Setting run time and
parts count
See III-11.4.5.
Displaying setĆ
ting time
See III-11.4.5.
Tool length
measurement
See III-11.4.2.
MACRO MENU OPR (OPRT)TOOLLF
Presetting tool life counter
Clearing executing data
See subsec. 11.4.11.
Displaying extended tool life management data
See subsec. 11.4.12.
Editing extended tool life management data
See subsec. 11.4.12.
Displaying pattern
menu
See subsec. 11.4.9.
Displaying pattern
data
See subsec. 11.4.9.
Setting macro
variables
See subsec. 11.4.8.
Tool offset value
Display of workĆ
piece coordinate
system
See III-11.4.6
Display of
macro variables
See subsec. 11.4.8.
Displaying softĆ
ware operator's
panel
See subsec. 11.4.10.
Displaying tool life
management data
See subsec.
11.4.11.

Leave a Reply

Your email address will not be published. Required fields are marked *