FANUC Series 16/18/160/180-Model C Machining Center Operators Manual

OPERATION
B–62764EN/01
11. SETTING AND DISPLAYING DATA
733
The table below lists the data set on each screen.
Table.11. Setting screens and data on them
No. Setting screen Contents of setting
Reference
item
1 Tool offset value Tool offset value
Tool length offset value
Cutter compensation value
III–11.4.1
Tool length measurement III–11.4.2
2 Setting data(handy) Parameter write
TV check
Punch code
Input unit (mm/inch)
I/O channel
Automatic insert of Sequence No.
Conversion of tape format (F15)
III–11.4.3
Sequence number comparison and stop III–11.4.4
3 Setting data (mirror image) Mirror image III–11.4.3
4 Setting data (timer) Parts required III–11.4.5
5 Macro variables Custom macro common variables
(#100 to #149) or (#100 to #199)
(#500 to #531) or (#500 to #599)
III–11.4.8
6 Parameter Parameter III–11.5.1
7 Pitch error Pitch error compensation data III–11.5.2
8 software operator’s panel Mode selection
Jog feed axis selection
Jog rapid traverse
Axis selection for Manual pulse generator
Multiplication for manual pulse generator
Jog feedrate
Feedrate override
Rapid traverse override
Optional block skip
Single block
Machine lock
Dry run
Protect key
Feed hold
III–11.4.10
9 Tool life data
(Tool life management)
Life count III–11.4.11
10 Tool life data
(Extended tool life man-
agement)
Life count type (cycle or minute)
Life value
Life counter
Tool number
H code
D code
New tool group
New tool number
Skipping tool
Clearing tool
III–11.4.12
11 Work coordinate system
setting
Work origin offset value III–11.4.6
12 Current position display
screen
Floating reference position III–11.1.7
D  s

Leave a Reply

Your email address will not be published. Required fields are marked *