FANUC Series 16/18/160/180-Model C Machining Center Operators Manual

OPERATION
B–62764EN/01
11. SETTING AND DISPLAYING DATA
741
ACTUAL POSITION O1000 N10010
(ACTUAL SPEED) F : 0MM/MIN
S : 0RPM
(PARTS COUNT) 114
(RUN TIME) 5H 3M
(CYCLE TIME) 0H 0M 6S
ABS
REL
O2000 N20010
ALL
D Display with two–path control
(14CRT, 9.5 LCD)
(RELATIVE)
(ACTUAL SPEED) F : 0MM/MIN
S : 0RPM
(PARTS COUNT) 114
(RUN TIME) 5H 3M
(CYCLE TIME) 0H 0M 6S
MEM STOP *** *** 12:34:56 HEAD1
X1 100.000
Y1 100.000
Z1 300.000
(ABSOLUTE)
X1 100.000
Y1 100.000
Z1 300.000
(MACHINE)
X1 100.000
Y1 200.000
Z1 300.000
(DISTANCE TO GO)
X1 000.000
Y1 000.000
Z1 000.000
(RELATIVE)
X1 100.000
Y1 200.000
Z1 300.000
(ABSOLUTE)
X1 100.000
Y1 200.000
Z1 300.000
(MACHINE)
X1 100.000
Y1 200.000
Z1 300.000
(DISTANCE TO GO)
X1 000.000
Y1 000.000
Z1 000.000
The current positions of the tool in the following coordinate systems are
displayed at the same time:
D Current position in the relative coordinate system
(relative coordinate)
D Current position in the work coordinate system
(absolute coordinate)
D Current position in the machine coordinate system
(machine coordinate)
D Distance to go (distance to go)
The distance remaining is displayed in the MEMORY or MDI mode. The
distance the tool is yet to be moved in the current block is displayed.
The least command increment is used as the unit for values displayed in
the machine coordinate system. However, the least input increment can
be used by setting bit 0 (MCN) of parameter 3104.
On the shared screen on the 14 CRT, or 9.5 LCD, only the coordinates
for the first to fifth axes are displayed initially whenever there are six or
more controlled axes. Pressing the
[ALL] soft key displays the
coordinates for the sixth and subsequent axes.
On the 9 CRT, relative coordinates cannot be displayed together with
absolute coordinates whenever there are five or more controlled axes.
Pressing the
[ALL] soft key toggles the display between absolute and
relative coordinates.
Explanations
D Coordinate display
D Distance to go
D Machine coordinate
system
D Displaing the sixth and
subsequent axes
D Displaying the fifth and
subsequent axes

Leave a Reply

Your email address will not be published. Required fields are marked *