FANUC Series 16/18/160/180-Model C Machining Center Operators Manual

OPERATION
B–62764EN/01
11. SETTING AND DISPLAYING DATA
747
The reading on the load meter can be displayed for each servo axis and
the serial spindle by setting bit 5 (OPM) of parameter 3111 to 1. The
reading on the speedometer can also be displayed for the serial spindle.
Procedure for displaying the operating monitor
1 Press function key
POS
to display a current position display screen.
2 Press the continuous–menu key
.
3 Press soft key
[MONI].
X : * * * 80% S1 : 201%
Y : * * * * * 0% (SPEED METER RPM)
Z : * * * * * 0% S1 : * * * 1500
OPERATING MONITOR O0001 N00001
(LOAD METER)
[
MEM STRT MTN *** 09:06:35
[ MONI ] [ ] [ ] [ ] [ (OPRT) ]
PART COUNT 5
RUN TIME 0H15M CYCLE TIME 0H 0M38S
ACT.F 3000 MM/M
The reading on the load meter can be displayed for up to eight servo axes
by setting parameters 3151 to 3158.
When all these parameters are set to 0, data is displayed only to the 3rd
axis.
When serial spindles are used, the reading on the load meter and
speedometer can be displayed only for the main serial spindle.
The bar graph for the load meter shows load up to 200% (only a value is
displayed for load exceeding 200%). The bar graph for the speedometer
shows the ratio of the current spindle speed to the maximum spindle speed
(100%).
The reading on the load meter depends on servo parameter 2086 and
spindle parameter 4127.
11.1.8
Operating Monitor
Display
Procedure
Explanations
D Display of the servo axes
D Display of the spindle
axes
D Unit of graph
D Load meter

Leave a Reply

Your email address will not be published. Required fields are marked *