FANUC Series 16/18/160/180-Model C Machining Center Operators Manual

OPERATION
11. SETTING AND DISPLAYING DATA
B–62764EN/01
750
Displays the program currently being executed in MEMORY or MDI
mode.
Procedure for displaying the program contents
1 Press function key
PROG
to display the program screen.
2 Press chapter selection soft key
[PRGRM].
The cursor is positioned at the block currently being executed.
O2000 ;
N100 G92 X0 Y0 Z70. ;
N110 G91 G00 Y–70. ;
N120 Z–70. ;
N140 G41 G03 X–17.5 Y17.5 R17.5 ;
N150 G01 X–25. ;
N160 G02 X27.5 Y27.5 R27.5 ;
N170 G01 X20. ;
N180 G02 X45. Y45. R45. ;
> _ S 0 T0000
MEM STRT *** 16:05:59
[ PRGRM ] [ CHECK ] [ CURRNT ] [ NEXT ] [ (OPRT) ]
PROGRAM O2000 N00130
N130 G42 G39 I–17.5 ;
On a 14 CRT or 9.5 LCD, the contents of the program are displayed on
the right half of the screen or on the entire screen (switched each time soft
key
[PRGRM] is pressed).
PROGRAM
O0006 N00000
+
O0003 ;
N001 G92X0Y0Z0;
N002 G90 G00 Z250.0 T11 M6;
N003 G43 Z0 H11;
N004 S30 M3
N005 G99 G81X400.0 R Y–350.0
Z–153.0R–97.0 F120;
N006 Y–550.0;
N007 G98Y–750.0;
N008 G99X1200.0;
N009 Y–550.0;
N010 G98Y–350.0;
N011 G00X0Y0M5;
N012 G49Z250.0T15M6;
N013 G43Z0H15;
N014 S20M3;
N015 G99G82X550.0Y–450.0
Z–130.0R–97.0P300F70;
N016 G98Y–650.0;
N017 G99X1050.0;
N018 G98Y–450.0;
N019 G00X0Y0M5;
N020 G49Z250.0T31M6;
N021 G43Z0H31;
N022 S10M3;
N023 G85G99X800.0Y–350.0
Z–153.0R47.0F50;
N024 G91Y–200.0K2;
N025 G28X0Y0M5;
N026 G49Z0;
N027 M0;
EDIT **** *** *** 07:12:55
O SRH
SRH
SRH
REWIND
11.2.1
Program Contents
Display
Explanations
D 14-inch CRT
9.5–inch LCD

Leave a Reply

Your email address will not be published. Required fields are marked *