FANUC Series 16/18/160/180-Model C Machining Center Operators Manual

OPERATION
11. SETTING AND DISPLAYING DATA
B–62764EN/01
754
PROGRAM CHECK O1000 N01010
(MODAL)
G00 G22 G40 G98 M
G17 G94 G49 G50 M
G90 G21 G80 G67 M
H T
B
F 1000.000 (ACT.F) 0MM/MIN
S 20 (ACT.S) 0RPM
>_
PRGRM
(OPRT)
CHECK
NEXT
(RELATIVE) (ABSOLUTE) (DIST TO
GO)
X1 0.000 X1 0.000 X1 0.000
Y1 0.000 Y1 0.000 Y1 0.000
Z1 0.000 Z1 0.000 Z1 0.000
PROGRAM CHECK O2000 N02010
(MODAL)
G00 G98 G25 G67 M
G97 G21 G22 G54 M
G69 G40 G90 G18 M
H T
B
F 0.000 (ACT.F) 0MM/MIN
S 30 (ACT.S) 0RPM
S 0 T0000
MEM STOP *** *** 14:00:00 HEAD1
(RELATIVE) (ABSOLUTE) (DIST TO
GO)
X2 0.000 X2 0.000 X2 0.000
Y2 0.000 Y2 0.000 Y2 0 .
000
Z2 0.000 Z2 0.000 Z2
0.000
D Display with two path control
(14CRT, 9.5LCD)
O0010 ;
G92 G90 X100.0 Y200. Z50. ;
G00 X0 Y0 Z0 ;
G01 Z250. F1000 ;
X50. Y20. ;
O0020 ;
G28 X10. Y10. Z10. ;
G00 X50. Y20. Z–50. ;
X100. ;
G01 Z–100. F2000 ;
The screen displays up to four blocks of the current program, starting from
the block currently being executed. The block currently being executed
is displayed in reverse video. During DNC operation, however, only three
blocks can be displayed.
The position in the workpiece coordinate system or relative coordinate
system and the remaining distance are displayed. The absolute positions
and relative positions are switched by soft keys
[ABS] and [REL].
When there are six or more controlled axes, pressing the
[ABS] soft key
toggles the display between the absolute coordinates for the first to fifth
axes and those for the sixth to eighth axes. Pressing the
[REL] soft key
toggles the relative coordinate display in the same way.
Up to 12 modal G codes are displayed.
During automatic operation, the actual speed, SACT, and repeat count are
displayed. The key input prompt (>_) is displayed otherwise.
Then bit 2 (PCT) of parameter No. 3108 is set to 1, the T codes specified
with the PMC (HD.T/NX.T) are displayed instead of those specified in
the program. Refer to the FANUC PMC Programming Manual
(B–61863E) for details of HD.T/NX.T.
Explanations
D Program display
D Current position display
D Modal G codes
D Display during automatic
operation
D T codes

Leave a Reply

Your email address will not be published. Required fields are marked *