FANUC Series 16/18/160/180-Model C Machining Center Operators Manual

OPERATION
B–62764EN/01
11. SETTING AND DISPLAYING DATA
757
When a machining program is executed, the machining time of the main
program is displayed on the program machining time display screen. The
machining times of up to ten main programs are displayed in
hours/minutes/seconds. When more than ten programs are executed, data
for the oldest programs is discarded.
Procedure for Stamping Machining Time
1 Select the memory operation mode, then press the
RESET
key.
2 Select the program screen, then select a program whose machining
time is to be calculated.
3 Execute the program to perform actual machining.
4 When the
RESET
key is pressed, or M02 or M30 is executed, the
machining time count operation stops. When the machining time
display screen is selected, the program number of the stopped main
program and its machining time are displayed.
To display the machining time display screen, use the procedure
below. (Machining time data can be displayed in any mode and
during background editing.)
S Press the function key
PROG
.
S Press the rightmost soft key once or twice to display soft key
[TIME].
S Press soft key
[TIME]. The machining time display screen appears.
PROGRAM (TIME) O0010 N00002
> _
EDIT **** *** *** 16:52:13
[ TIME ] [ ] [ ] [ ] [ (OPRT) ]
NO. TIME
O0020 12H48M02S
Machining time display screen
11.2.6
Stamping the Machining
Time
Procedure 1
Machining time
calculation and display

Leave a Reply

Your email address will not be published. Required fields are marked *