FANUC Series 16/18/160/180-Model C Machining Center Operators Manual

OPERATION
B–62764EN/01
11. SETTING AND DISPLAYING DATA
765
This section describes the screens displayed by pressing function key
PROG
in the EDIT mode. Function key
PROG
in the EDIT mode can
display the program editing screen and the program list screen (displays
memory used and a list of programs). Pressing function key
PROG
in the
EDIT mode can also display the conversational graphics programming
screen and the floppy file directory screen. See III–9 and 10 for the
program editing screen and conversational graphics programming screen.
See III–8 for the floppy file directory screen.
Displays the number of registered programs, memory used, and a list of
registered programs.
Procedure for displaying memory used and a list of programs
1 Select the EDIT mode.
2 Press function key
PROG
.
3 Press chapter selection soft key
[DIR].
PROGRAM (NUM.) MEMORY (CHAR.)
USED: 60 3321
FREE: 2 429
O0010 O0001 O0003 O0002 O0555 O0999
O0062 O0004 O0005 O1111 O0969 O6666
O0021 O1234 O0588 O0020 O0040
> _ S 0 T0000
MDI **** *** *** 16:05:59
[ PRGRM ] [ DIR ] [ ] [ C.A.P. ] [ (OPRT) ]
PROGRAM DIRECTORY O0001 N00010
11.3
SCREENS
DISPLAYED BY
FUNCTION KEY
(IN THE EDIT MODE)
PROG
11.3.1
Displaying Memory
Used and a List
of Programs


Leave a Reply

Your email address will not be published. Required fields are marked *