FANUC Series 16/18/160/180-Model C Machining Center Operators Manual

OPERATION
11. SETTING AND DISPLAYING DATA
B–62764EN/01
772
Tool offset values, tool length offset values, and cutter compensation
values are specified by D codes or H codes in a program. Compensation
values corresponding to D codes or H codes are displayed or set on the
screen.
Procedure for setting and displaying the tool offset value
1 Press function key
OFFSET
SETTING
.
For the two–path control, select the tool post for which tool
compensation values are to be displayed with the tool post selection
switch.
2 Press chapter selection soft key
[OFFSET] or press
OFFSET
SETTING
several
times until the tool compensation screen is displayed.
The screen varies according to the type of tool offset memory.
OFFSET O0001 N00000
NO. DATA NO. DATA
001 1.000 009 0.000
002 –2.000 010 –7.500
003 0.000 011 12.000
004 5.000 012 –20.000
005 0.000 013 0.000
006 0.000 014 0.000
007 0.000 015 0.000
008 0.000 016 0.000
ACTUAL POSITION (RELATIVE)
X 0.000 Y 0.000
Z 0.000
Tool offset memory A
> _
MDI **** *** *** 16:05:59
[ OFFSET ] [ SETING ] [ WORK ] [ ] [ (OPRT) ]
OFFSET O0001 N00000
NO. GEOM(H) WEAR(H) GEOM(D) WEAR(D)
001 10.000 0.000 0.000 0.000
002 –1.000 0.000 0.000 0.000
003 0.000 0.000 0.000 0.000
004 20.000 0.000 0.000 0.000
005 0.000 0.000 0.000 0.000
006 0.000 0.000 0.000 0.000
007 0.000 0.000 0.000 0.000
008 0.000 0.000 0.000 0.000
ACTUAL POSITION (RELATIVE)
X 0.000 Y 0.000
Z 0.000
Tool offset memory C
> _
MDI **** *** *** 16:05:59
[ OFFSET ] [ SETING ] [ WORK ] [ ] [ (OPRT) ]
11.4.1
Setting and Displaying
the Tool Offset Value
Procedure

Leave a Reply

Your email address will not be published. Required fields are marked *