FANUC Series 16/18/160/180-Model C Machining Center Operators Manual

OPERATION
B–62764EN/01
11. SETTING AND DISPLAYING DATA
775
The length of the tool can be measured and registered as the tool length
offset value by moving the reference tool and the tool to be measured until
they touch the specified position on the machine.
The tool length can be measured along the X–, Y–, or Z–axis.
Procedure for tool length measurement
1 Use manual operation to move the reference tool until it touches the
specified position on the machine (or workpiece.)
2 Press function key
POS
several times until the current position
display screen with relative coordinates is displayed.
MEM STRT MTN *** 09:06:35
[ ABS ] [ REL ] [ ALL ] [ HNDL ] [ OPRT ]
ACTUAL POSITION(RELATIVE) O1000 N00010
PART COUNT 5
RUN TIME 0H15M CYCLE TIME 0H 0M38S
ACT.F 3000 MM/M S 0 T0000
X 123.456
Y 363.233
Z 0.000
3 Reset the relative coordinate for the Z–axis to 0 (see III–11.1.2 for
details).
4 Press function key
OFFSET
SETTING
several times until the tool compensation
screen is displayed.
5 Use manual operation to move the tool to be measured until it touches
the same specified position. The difference between the length of the
reference tool and the tool to be measured is displayed in the relative
coordinates on the screen.
6 Move the cursor to the compensation number for the target tool (the
cursor can be moved in the same way as for setting tool compensation
values).
7 Press the address key
Z
.
If either
X
or
Y
key is depressed instead of
Z
key, the X or Y
axis relative coordinate value is input as an tool length compensation
value.
11.4.2
Tool Length
Measurement
Procedure

Leave a Reply

Your email address will not be published. Required fields are marked *