FANUC Series 16/18/160/180-Model C Machining Center Operators Manual

OPERATION
B–62764EN/01
11. SETTING AND DISPLAYING DATA
799
Chopping data, including the reference point (R point), upper dead point,
lower dead point, and chopping feedrate, can be displayed and set by
using the chopping screen.
Procedure for displaying and setting chopping data
1 Press the
OFFSET
SETTING
function key.
2 Press the continuous menu key
several times until [CHOP] is
displayed.
3 Press the [CHOP] soft key.
The following chopping screen appears:
R (REFERENCE) POINT = 50.000
UPPER DEAD POINT = 40.000
LOWER DEAD POINT = 10.000
CHOPPING FEED RATE = 2000
CHOPPING PARAMETER O1000 N10000
> _
MDI **** *** *** 22:07:08
[ ] [ ] [ TEACH ] [ +INPUT ] [ INPUT ]
D Position the cursor to the item to be set.
D Enter data, then press the [INPUT] soft key.
D To append the entered data to the current data, press the [+INPUT] soft
key.
The set data is displayed.
The reference point (R point), upper dead point, and lower dead point can
be set by teaching the current position (absolute coordinates).
D Move the current position (absolute coordinates) along the chopping
axis to the position to be taught.
D Position the cursor to the item to be set.
D Press the [TEACH] soft key, then the [EXEC] soft key.
The current position (absolute coordinates) is set for that item.
The data for each item displayed on the chopping screen can also be
changed by executing a G81.1 command.
11.4.13
Displaying and Setting
Chopping Data

Explanations
D Numerical input
D Teaching the position
D G81.1
CHOP

Leave a Reply

Your email address will not be published. Required fields are marked *