FANUC Series 16/18/160/180-Model C Machining Center Operators Manual

OPERATION
11. SETTING AND DISPLAYING DATA
B–62764EN/01
800
If bit 7 (CHPX) of parameter No. 8360 is set to 1, the chopping feedrate
cannot be set by using the chopping screen.
The chopping screen can be used to set chopping data regardless of the
current mode, even during automatic or manual operation that includes
chopping. If the level of memory protection signal KEY2 (G046#4) is
currently low, however, chopping data cannot be set.
Limitations
D Chopping feedrate
D Data setting conditions

Leave a Reply

Your email address will not be published. Required fields are marked *