FANUC Series 16/18/160/180-Model C Machining Center Operators Manual

OPERATION
12. GRAPHICS FUNCTION
B–62764EN/01
814
It is possible to draw the programmed tool path on the 9–inch, 14–inch
CRT screen, or 9.5/8.4–inch LCD screen, which makes it possible to
check the progress of machining, while observing the path on the CRT
screen.
In addition, it is also possible to enlarge/reduce the screen.
Before drawing, graphic parameters must be set.
When the dynamic graphics function is used, the graphics function
described in this section cannot be used. See Section 12.2 for the dynamic
graphics function.
Graphics display procedure
1 Press function key
GRAPH
. Press
CUSTOM
GRAPH
for a small MDI unit.
The graphic parameter screen shown below appears. (If this screen
does not appear, press soft key
[PARAM].)
GRAPHIC PARAMETER
MDI
**** *** ***
14 : 23 : 54
O0000
N00000
GRAPH
AXES P=
(XY=0.YZ=1,ZY=2, XZ=3, XYZ=4, ZXY=5)
RANGE (MAX.)
X= 115000 Y= 150000 Z= 0
RANGE (MIN.)
X= 0 Y= 0 Z= 0
SCALE K= 70
GRAPHIC CENTER
X= 57500 Y= 75000 Z= 0
PROGRAM STOP N= 0
AUTO ERASE A= 1
PARAM
4
2 Move the cursor with the cursor keys to a parameter to set.
3 Enter data, then press the
INPUT
key.
4 Repeat steps 2 and 3 until all required parameters are specified.
5 Press soft key
[GRAPH].
12.1
GRAPHICS DISPLAY


Leave a Reply

Your email address will not be published. Required fields are marked *