FANUC Series 16/18/160/180-Model C Machining Center Operators Manual

OPERATION
B–62764EN/01
12. GRAPHICS FUNCTION
815
6 Automatic operation is started and machine movement is drawn on
the screen.
MEM
**** *** ***
14 : 23 : 03
0001
00012
GRAPHPARAM
Z
XY
S 0T
X 0.000
Y 0.000
Z 0.000
The size of the graphic screen will be as follows:
Gc : Center of the screen
Note : ( ) indicate the values for a 14” CRT.
Gc
45(75)mm
72mm
(120)
72mm
(120)
45(75)mm
Fig.12.1 (a) Graphic range
As shown in Fig.12.1 (a), the maximum graphics range is an area of
approx. 144 mm (width) × 90 mm (height) for a 9 CRT and approx. 240
mm (width) ×150 mm (height) for a 14” CRT.
To draw a section of the program within the actual graphics range, set the
graphics range using one of the following two methods:
1 . Set the center coordinates of the range and the magnification.
2 . Set the maximum and minimum coordinates for the range in the
program.
Whether 1 or 2 is used depends on which parameters are set last. A
graphics range which has been set is retained when the power is turned
off.
Explanation
D RANGE
(Actual graphic range)
D Setting the graphics
range

Leave a Reply

Your email address will not be published. Required fields are marked *