FANUC Series 16/18/160/180-Model C Machining Center Operators Manual

OPERATION
12. GRAPHICS FUNCTION
B–62764EN/01
818
AXES
Specify the plane to use for drawing. The user can choose from the
following six coordinate systems.
With two–path control, a different drawing coordinate system can be
selected for each tool post.
Y
Z
X
X
X
X
YYZ
Z
Z
Z
Y
Y
(1) (2) (3)
(4) (5)
(6)
= 0 : Select (1)
= 1 : Select (2)
= 2 : Select (3)
= 3 : Select (4)
= 4 : Select (5)
= 5 : Select (6)
The rotating angle (horizontal, vertical) for isometric display of 5) and 6) is
fixed at 45°in both cases.
Fig12.1 (d) Coordinate system
RANGE (Max., Min.)
Set the graphic range displayed on the screen by specifying maximum
and minimum values along each axis.
X=Maximum value X=Minimum value
Y=Maximum value Y=Minimum value
Z=Maximum value Z=Minimum value
Valid range: 0 to 9999999
NOTE
1 The units are 0.001 mm or 0.0001 inch. Note that the
maximum value must be greater than the minimum value for
each axis.
2 When setting the graphics range with the graphics
parameters for the maximum and minimum values, do not
set the parameters for the magnification and screen center
coordinates afterwards. Only the parameters set last are
effective.
SCALE
Set the graphic magnification
The setting range is 0 to 10000 (unit:0.01 time).
D Graphics parameter

Leave a Reply

Your email address will not be published. Required fields are marked *