FANUC Series 16/18/160/180-Model C Machining Center Operators Manual

OPERATION
12. GRAPHICS FUNCTION
B–62764EN/01
822
2 There are two screens for setting drawing parameters.
Press the page key according to the setting items for selecting
screens.
3 Set the cursor to an item to be set by cursor keys.
4 Input numerics by numeric keys.
5 Press the
INPUT
key.
The input numerics are set by these operations and the cursor
automatically moves to the next setting items. The set data is held even
after the power is turned off.
6 Set the operation mode to the memory mode, press function key
PROG
, and call the part program which should be drawn.
7 Press function key
GRAPH
(
CUSTOM
GRAPH
for a small MDI) several times to
redisplay the
PATH GRAPHIC (PARAMETER) screen, then press soft
key
[EXEC] to display the PATH GRAPHIC (EXECUTION) screen.
MEM
**** *** ***
10 : 10 : 40
PATH GRAPHIC (EXECUTION)
O1126 N01126
Y
X
25.8
ERASEAUTO
START
STOP REWIND
8 Press soft key [(OPRT)], then press soft key [AUTO] or [START].
Pressing
[AUTO] enables automatic scaling. See item 7 in
introduction of path drawing and the description of soft key
[AUTO]
in Explanations for details. Drawing is now started. During drawing,
the message ”
DRAWING” blinks at the lower–right corner of the CRT
screen.
9 Press soft key
[STOP] to pause drawing. The indication of “STOP”
blinks at the lower right corner on the CRT screen. Press soft key
[START] to start drawing. In addition, press soft key [REWIND] to
redraw from the top of program before pressing soft key
[START].
10 Execute the last of part program (M02/M30) to end drawing. This
will cause, blinking of the “
DRAWING” light to turn off. The tool
path view drawn can be retained until the power is turned off
unless a new tool path view is drawn.

Leave a Reply

Your email address will not be published. Required fields are marked *