FANUC Series 16/18/160/180-Model C Machining Center Operators Manual

OPERATION
12. GRAPHICS FUNCTION
B–62764EN/01
830
Solid graphics drawing procedure
1 To draw a machining profile, necessary data must be set beforehand.
So press the function key
GRAPH
(
CUSTOM
GRAPH
for the small MDI).
The screen of ”
SOLID GRAPHIC (PARAMETER)” is displayed.
SOLID GRAPHIC (PARAMETER) O0000 N00003
BLANK FORM P=
X= 0.000 Y= 0.000 Z= 0.000
I= 120.000 J= 100.000 K= 40.000
TOOL FORM P= 2
R= 7.500 K= 0.000
PROJECTION P= 3
Q= 1 R= 0
INTENSITY P= 4
(0123456) Q= 2 R= 1
START SEQ.NO. N= 0
END SEQ.NO. N= 0
ANIM. SPEED N= 0
MDI
**** *** ***
14 : 42 : 17
>_
BLANK
EXEC
REVIEW
PARAM
2 Use a cursor key to move the cursor to an item to be set.
3 Input numerics for the item at the cursor using the numeric key.
4 Press the
INPUT
.
Input numerics can be set by these operations and the cursor moves to the
next setting item automatically. The set data is retained even if the power
is turned off.
See Explanations for details on settings.
5 To draw a blank figure, display the
SOLID GRAPHIC (BLANK)
screen by pressing soft key [BLANK] on the SOLID GRAPHIC
(PARAMETER)
screen of step 1 above.
SOLID GRAPHIC (BLANK)
O1126 N1126
Z
Y
X
MEM
**** *** ***
10 : 10 : 40
ANEW
TILT
+TILT
ROT
+ROT
Procedure
D SOLID GRAPHIC
(BLANK)

Leave a Reply

Your email address will not be published. Required fields are marked *