FANUC Series 16/18/160/180-Model C Machining Center Operators Manual

OPERATION
B–62764EN/01
12. GRAPHICS FUNCTION
831
6 Press soft key [ANEW]. This allows the blank figure drawing to be
performed based on the blank figure data set.
7 Press soft keys
[+ROT] [–ROT] [+TILT], and [–TILT], when
performing drawing by changing the drawing directions. Parameters
P and Q for the drawing direction are changed and the figure is
redrawn with the new parameters.
8 Set the operation mode to the memory mode, press function key
PROG
, and call the subject part program of drawing.
9 To draw a machining profile, display the
SOLID GRAPHIC
(EXECUTION)
screen by pressing soft key [EXEC] on the SOLID
GRAPHIC (PARAMETER)
screen of step 1 above.
SOLID GRAPHIC (EXECUTION)
Z
Y
X
O1126 N01126
A.ST
F.ST
STOP REWIND
O1126 N01126
Y
X
SOLID GRAPHIC (EXECUTION)
A.ST
F.ST
STOP REWIND
D SOLID GRAPHICS
(EXECUTION)

Leave a Reply

Your email address will not be published. Required fields are marked *