FANUC Series 16/18/160/180-Model C Machining Center Operators Manual

OPERATION
12. GRAPHICS FUNCTION
B–62764EN/01
832
10 Press soft key [(OPRT)] and press either soft key [A.ST] or [F.ST].
When
[A.ST] is pressed, the status of machining in progress is drawn
by simulation. When
[F.ST] is pressed, the profile during machining
is not drawn. Only the finished profile produced by the program is
drawn. This allows drawing to be started.
When “
STOP” is not displayed at the lower right corner of the screen,
the program is executed from its head. “
DRAWING” blinks at the
lower right corner of CRT screen during drawing.
11 Press soft key
[STOP] to stop drawing temporarily. Drawing is
stopped after drawing the current block and “
STOP” blinks at the
lower right corner of CRT screen. Press soft key
[A.ST] or [F.ST]
when restarting drawing. Press soft key [REWIND] and then the
[A.ST] or [F.ST] if redrawing from the head. It is possible to continue
drawing after changing the solid graphic parameters in temporary
stop.
12 When the end of program (M02 or M03) is executed, the drawing
ends and the blinking of “
DRAWING” stops. Then, the final finish
figure is drawn on the CRT screen. The drawn figure view is retained
until the power is turned off as long as a new machine figure view is
drawn.
13 The color, intensity, or drawing direction of a machining figure which
has been drawn can be changed and the figure redrawn.
To redraw the figure, first change the parameters for the color,
intensity, or drawing direction on the
SOLID GRAPHIC
(PARAMETER)
screen shown in step 1, then press soft key
[REVIEW] to display the SOLID GRAPHIC (REVIEW) screen.
SOLID GRAPHIC (REVIEW)
Z
Y
X
O1126 N01126
ANEW
+ROT
ROT
+TILT TILT
14 Press soft key [(OPRT)], then press soft key [ANEW]. The machining
figure is redrawn with the color, intensity, or drawing direction set in
step 13.
D REVIEW

Leave a Reply

Your email address will not be published. Required fields are marked *