FANUC Series 16/18/160/180-Model C Machining Center Operators Manual

OPERATION
B–62764EN/01
12. GRAPHICS FUNCTION
833
15 To redraw the figure in a different mode, press soft key [+ROT],
[–ROT], [+TILT], or [–TILT]. Parameters P and Q for the drawing
direction are changed and the figure is redrawn with the new
paramaters.
16 The machined figure can be drawn on the tri–plane view.
To draw a triplane view, press the rightmost soft key (next–menu key)
on the
SOLID GRAPHIC (PARAMETER) screen of step 1 above, then
press soft key
[3–PLN] and [(OPRT)]. The SOLID GRAPHIC
(3–PLANE)
screen appears.
SOLID GRAPHIC (3–PLANE)
01126 N01126
←↑
Each time soft key [ ] is pressed, the side–view drawings dis-
played change as follows.
Right view and rear view
Rear view and left view
Left view and front view
Front view and right view
17
18 The sectional position of side view can be changed by the soft keys
[
], [], [], and [].
With the sectional position of the left/right side view, the marks
Y and
B indicating the sectional position can be moved using the soft keys
[
] and [].
With the sectional position of rear/front side view, the marks
" and A
indicating the sectional position can be moved using the soft keys [],
and [
]. Keep the keys depressed to change sectional/views
continuously.
D Triplane view drawing

Leave a Reply

Your email address will not be published. Required fields are marked *