FANUC Series 16/18/160/180-Model C Machining Center Operators Manual

OPERATION
B–62764EN/01
12. GRAPHICS FUNCTION
835
Set the machining direction of tools. The relationship between the setting
value and machining direction is as shown below.
P Machining direction of tools
0,1 Parallel to the Z–axis (perform machining from the + direction)
2 Parallel to the X–axis (perform machining from the + direction)
3 Parallel to the Y–axis (perform machining from the + direction)
4 Parallel to the Z–axis (perform machining from the – direction)
5 Parallel to the X–axis (perform machining from the – direction)
6 Parallel to the Y–axis (perform machining from the – direction)
Set the dimensions of tool. The relationship between the displayed
address and setting value is as shown below:
Address Setting numerics
R Radius of tool
K Distance from the program point to tool tip (normally 0)
K
Program point
Tip of the tool
The relationship between graphic method and direction and setting value
is as shown below:
P Graphic method and direction
0, 4 Oblique projection view (+ X–axis)
1, 5 Oblique projection view (+ Y–axis)
2, 6 Oblique projection view (– X–axis)
3, 7 Oblique projection view (–Y–axis)
This setting value can also be incremented or decremented by the soft
keys
[+ROT] or [– ROT]. In this case, if the setting value exceeds 7, it
returns to 0. If it is smaller than 0, it becomes 7.
D TOOL FORM
Machining tool
orientation (P)
Dimensions of tools
(R,K)
D PROJECTION
Graphics method
and direction (P)

Leave a Reply

Your email address will not be published. Required fields are marked *