FANUC Series 16/18/160/180-Model C Machining Center Operators Manual

OPERATION
12. GRAPHICS FUNCTION
B–62764EN/01
836
Set the slant direction of the projection axis in the case of oblique
projection drawing. Moreover, plane view can be specified. The
relationship between the setting value and slant direction is as shown
below:
Q Slant direction
3 Plane view
2 (0,2) direction ; α=90°in the figure below
1 (1,2) direction ; α=60°in the figure below
0 (2,2) direction ; α=45°in the figure below
–1 (2,1) direction ; α=30°in the figure below
–2 (2,0) direction ; α=0°in the figure below
This setting value can also be incremented or decremented by 1 using soft
key
[+ TILT] or [–TILT].
Example) The angle of projection is changed by the set value.
Variations of the above figure determined by set values are shown below.
(i) Set value:3
(ii) Set value: 2
(iii) Set value: 1
(iv) Set value: 0
(v) Set value: –1 (vi) Set value: –2
(Two–dimensional drawing)
(α=90°)(α=60°)
(α=45°)
(α=30°)(α=0°)
α
α
A
B
The angle of projection
(A,B)
Tilting angle (Q)

Leave a Reply

Your email address will not be published. Required fields are marked *