FANUC Series 16/18/160/180-Model C Machining Center Operators Manual

OPERATION
B–62764EN/01
12. GRAPHICS FUNCTION
837
Set the direction of the vertical axis.
R VERTICAL AXIS
0, 1 Z–axis
2 X–axis
3 Y–axis
The direction of the vertical axis which is set is effective by executing
graph.
Specify the intensity of the drawing screen when performing drawing on
the monochrome CRT, and the color of the drawing screen when
performing drawing on the color CRT screen. The relationship between
the setting, intensity, and color is as shown below:
However, when the plane view is displayed on the monochrome CRT.
The brighter surface, whichever is specified by P or Q becomes the top
surface.
Setting value Intensity Color
0 Maximum brightness White
1 Red
2
Dark
Green
3
Yellow
4
Light
Blue
5 Purple
6 Light blue
The relationship between the display address, surface, and line on the
machined figure view is as shown below:
Address
Oblique projection
view
Plane view Triplane view
P Upper surface Upper surface Upper/lower surface
Q Side surface Middle surface Left/right surface
R Ridge Ridge Ridge
Remarks The intensity/color of
front surface is
between P and Q
Lower surface
is blank
The intensity/color of
plane view is between
P and Q
VERTICAL AXIS (R)
D INTENSITY

Leave a Reply

Your email address will not be published. Required fields are marked *