FANUC Series 16/18/160/180-Model C Machining Center Operators Manual

OPERATION
12. GRAPHICS FUNCTION
B–62764EN/01
838
P
Q
P+Q
P
Q
Blank
P
P+Q
Q
Oblique projection view
Plane view
Triplan view
Specify the start sequence number and end sequence number of each
drawing in a five–digit numeric. The subject part program is executed
from the head. But only the part enclosed by the start sequence number
and end sequence numeric is drawn. When 0 is commanded as the start
sequence number, the program is drawn from its head. When 0 is
commanded as the end sequence number, the program is drawn to its end.
The comparison of sequence number is performed regardless of main
program and subprogram.
Set interval of animated simulation drawing ranging from 0 to 255.
Every time the machining proceeds by the number set, the drawing is
repeated. If 0 is set, drawing is repeated at every 1 block execution.
Soft key Function
[A.ST] Simulate and draw the progress of machining.
[F.ST]
No figure during machining is drawn and only the final
finish figure by that program is drawn.
[STOP]
When pressed, stops drawing at the end of block (single
block stop).
[REWIND]
Press this key to perform drawing from the head of part
program. Heading is performed automatically after execu-
tion of program end (M02/M30).
No part program which has not been registered in memory can be drawn.
It is also necessary that the M02 or M30 be commanded at the end of the
part program.
D START SEQ. NO. and
END SEQ. NO.
D ANIM. SPEED
D Soft key functions on the
“SOLID GRAPHIC
(EXECUTION)”screen
D Graphics program

Leave a Reply

Your email address will not be published. Required fields are marked *