FANUC Series 16/18/160/180-Model C Machining Center Operators Manual

OPERATION
B–62764EN/01
12. GRAPHICS FUNCTION
839
It is possible to specify BLANK FORM and TOOL FORM in the part
program. The command format is as shown below. If it is commanded
during execution of drawing, the item corresponding to the screen of
SOLID GRAPHIC (PARAMETER)” is set and drawing continues with the
set data.
S Command of BLANK FORM
G10 L90 P_X_Y_Z_I_J_K_ ;
The command value succeeding the address is the same as the
numeric set to the address being displayed at the item of
BLANK
FORM
of “SOLID GRAPHIC (PARAMETER)”. If BLANK FORM
is commanded, drawing continues after a new blank figure is
drawn.
S Command of TOOL FORM
G10 L91 P_R_K_ ;
The command value succeeding the address is the same as the
numeric set to the address being displayed at the item of
TOOL
FORM
of screen “SOLID GRAPHIC (PARAMETER)”. If 0 is
commanded with the tool radius value, no machining simulation
is performed thereafter.
Parameter 6500 (DPO, bit 5) is used to specify whether to display the
coordinates of the current position on
SOLID GRAPHIC screen.
In solid graphics, parameter 6501 (TLC, bit 1) is used to specify whether
to apply tool length offset.
Parameter 6501 (3PL, bit 2) is used to select whether to draw a triplane
view with the third–angle or first–angle projection.
Parameter 6501 (RID, bit 3) is used to specify whether to draw ridges in
plane view drawing.
Parameter 6501 (FIM, bit 4) is used to specify whether to display a solid
graphics in the rough mode or in the fine mode. When a solid graphics
is drawn in the fine mode, the drawing speed is slower than when drawn
in the rough mode.
In triplane drawing, a value can be specified for changing the position of
the cross section while the soft key is held down. A value from 0 to 10
can be set. When 0 is specified, a value of 1 is used. (Parameter No. 6515)
D Specifying the blank
form and tool form in the
part program
D Display of the coordinate
value
D TOOL COMP.
D Graphic method
D Ridge drawing
D Display mode
D Cross section position
change

Leave a Reply

Your email address will not be published. Required fields are marked *