FANUC Series 16/18/160/180-Model C Machining Center Operators Manual

OPERATION
12. GRAPHICS FUNCTION
B–62764EN/01
842
The background drawing function enables the drawing of a figure for one
program while machining a workpiece under the control of another
program.
Procedure for Background Drawing
1 Press the
GRAPH
function key (
CUSTOM
GRAPH
for a small MDI).
2 Press the [PARAM] soft key. The following screen appears:
MDI
**** *** ***
21 : 20 : 05
>_
EXEC
SCALE
POS
(OPRT)
PATH GRAPHIC (PARAMETER–1) O0001 N00001
AXES P= 0
(XY=0, YZ=1, ZY=2, XZ=3, XYZ=4, ZXY=5, 2P=6)
ANGLE
ROTATION A = 0
TILTING A = 0
SCALE K = 0.00
CENTER OR MAX./MIN.
X= 0.000 X= 0.000 X= 0.00
X= 0.000 X= 0.000 X= 0.00
START SEQ. NO. N= 0
END SEQ. NO. N= 0
BGGRP
PARAM
3 Press the [(OPRT)] soft key.
4 To select the program to be used for drawing, enter the number of that
program, then press the [O SRH] soft key. (The O number at the top
right of the screen indicates the selected program.) Repeatedly
pressing only the [O SRH] soft key selects the registered programs in
turn.
To input a graphic parameter, the [INPUT] soft key can be used
instead of the
INPUT
MDI key.
5 Press the left–most soft key
(return menu key), to return the soft
keys to the state existing upon the completion of step 2.
6 Perform dynamic graphic display, as described in Section III–12.2.
Immediately after entering background drawing mode, the program
which was selected previously remains selected. Any program can be
selected for background drawing, by using the background drawing
screen.
If no program is selected prior to entering background drawing mode, the
program number is set to 0. In such a case, drawing cannot be started until
the program to be used for drawing is specified.
12.3
BACKGROUND
DRAWING

O SRH INPUT
Explanations
D Program selection

Leave a Reply

Your email address will not be published. Required fields are marked *