FANUC Series 16/18/160/180-Model C Machining Center Operators Manual

OPERATION
12. GRAPHICS FUNCTION
B–62764EN/01
844
Bit 5 (DPO) of parameter No. 6500 can be used to specify whether the
coordinates of the current position are to be displayed on the tool path
drawing.
In background drawing mode, modal information F, S, and T is displayed,
together with the current position. If the [POS] soft key has been selected
for dynamic graphic display, however, F, S, and T are not displayed.
CAUTION
Once an alarm is issued during background drawing,
drawing is stopped and the alarm description is displayed
at the bottom right of the screen. To release the alarm state,
press the MDI key. Note that pressing the key
will also stop foreground machining if currently in progress.
Note, however, that bit 0 (RST) of parameter No. 8100 can
be used to specify that machining will not be stopped if the
key is pressed during background drawing.
CAN
RESET
RESET
D Displaying the
coordinates

Leave a Reply

Your email address will not be published. Required fields are marked *