FANUC Series 16/18/160/180-Model C Machining Center Operators Manual

APPENDIX
E. STATUS WHEN TURNING POWER ON,
WHEN CLEAR AND WHEN RESET
B–62764EN/01
880
Item ResetClearedWhen turning power on
Action in
Movement × × ×
opera-
tion
Dwell × × ×
tion
Issuance of M, S and T
codes
× × ×
Tool length compensa-
tion
× Depending on
parameter
LVK(No.5003#6)
f : MDI mode
Other modes depend
on parameter
LVK(No.5003#6).
Cutter compensation × × f : MDI mode
× : Other modes
Storing called subpro-
gram number
× × (Note 2) f : MDI mode
× : Other modes
(Note 2)
Output
signals
CNC alarm signal
AL
Extinguish if there is no cause for
the alarm
Extinguish if there is
no cause for the
alarm
Extinguish if there is
no cause for the alarm
Reference position
return completion LED
× f
(× : Emergency stop)
f
(× : Emergency stop)
S, T and B codes × f f
M code × × ×
M, S and T strobe sig-
nals
× × ×
Spindle revolution sig-
nal (S analog signal)
× f f
CNC ready signal
MA
ON f f
Servo ready signal
SA
ON (When other than servo alarm) ON (When other
than servo alarm)
ON (When other than
servo alarm)
Cycle start LED (STL) × × ×
Feed hold LED (SPL) × × ×
NOTE
1 When heading is performed, the main program number is displayed.
2 When a reset is performed during execution of a subprogram, control returns the head of main
program.
Execution cannot be started from the middle of the subprogram.

Leave a Reply

Your email address will not be published. Required fields are marked *