FANUC Series 16/18/160/180-Model C Machining Center Operators Manual

APPENDIX
B–62764EN/01
G. ALARM LIST
883
Number ContentsMessage
028 ILLEGAL PLANE SELECT In the plane selection command, two or more axes in the same direction
are commanded.
Modify the program.
029 ILLEGAL OFFSET VALUE The offset values specified by H code is too large.
Modify the program.
030 ILLEGAL OFFSET NUMBER The offset number specified by D/H code for tool length offset or cutter
compensation is too large. Modify the program.
031 ILLEGAL P COMMAND IN G10 In setting an offset amount by G10, the offset number following address
P was excessive or it was not specified.
Modify the program.
032 ILLEGAL OFFSET VALUE IN G10 In setting an offset amount by G10 or in writing an offset amount by sys-
tem variables, the offset amount was excessive.
033 NO SOLUTION AT CRC A point of intersection cannot be determined for cutter compensation C.
Modify the program.
034 NO CIRC ALLOWED IN ST–UP /EXT
BLK
The start up or cancel was going to be performed in the G02 or G03
mode in cutter compensation C. Modify the program.
035 CAN NOT COMMANDED G39 G39 is commanded in cutter compensation B cancel mode or on the
plane other than offset plane. Modify the program.
036 CAN NOT COMMANDED G31 Skip cutting (G31) was specified in cutter compensation mode.
Modify the program.
037 CAN NOT CHANGE PLANE IN CRC G40 is commanded on the plane other than offset plane in cutter com-
pensation B. The plane selected by using G17, G18 or G19 is changed
in cutter compensation C mode. Modify the program.
038 INTERFERENCE IN CIRCULAR
BLOCK
Overcutting will occur in cutter compensation C because the arc start
point or end point coincides with the arc center.
Modify the program.
041 INTERFERENCE IN CRC Overcutting will occur in cutter compensation C. Two or more blocks
are consecutively specified in which functions such as the auxiliary
function and dwell functions are performed without movement in the cut-
ter compensation mode. Modify the program.
042 G45/G48 NOT ALLOWED IN CRC Tool offset (G45 to G48) is commanded in cutter compensation. Modify
the program.
043 ILLEGAL T–CODE COMMAND In a system using the DRILL–MATE with an ATC, a T code was not spe-
cified together with the M06 code in a block. Alternatively, the Tcode was
out of range.
044 G27–G30 NOT ALLOWED IN FIXED
CYC
One of G27 to G30 is commanded in canned cycle mode.
Modify the program.
046 ILLEGAL REFERENCE RETURN
COMMAND
Other than P2, P3 and P4 are commanded for 2nd, 3rd and 4th refer-
ence position return command.
047 ILLEGAL AXIS SELECT For startup of three–dimensional tool compensation or three–dimen-
sional coordinate conversion, two or more axes were specified in the
same direction (basic and parallel axes.)
048 BASIC 3 AXIS NOT FOUND For startup of three–dimensional tool compensation or three–dimen-
sional coordinate conversion, the three basic axes used when X
p,
Y
p,
and Z
p
are omitted were not specified in parameter No. 1022.
050 CHF/CNR NOT ALLOWED IN THRD
BLK
Chamfering or corner R is commanded in the thread cutting block.
Modify the program.
051 MISSING MOVE AFTER CHF/CNR Improper movement or the move distance was specified in the block
next to the chamfering or corner R block.
Modify the program.
052 CODE IS NOT G01 AFTER CHF/
CNR
The block next to the chamfering or corner R block is not G01,G02,or
G03. Modify the program.

Leave a Reply

Your email address will not be published. Required fields are marked *