FANUC Series 16/18/160/180-Model C Machining Center Operators Manual

APPENDIX
B–62764EN/01
H. OPERATION OF PORTABLE
TAPE READER
905
No. DescriptionsName
7 Winder Used to advance or rewind the tape.
8
Metal A
Fastener
(usually kept open)
When removing the rolled tape, reduce the
internal diameter by pushing the fastener.
Push
Paper tape
Paper tape
Insert
9 Cover lock Be sure to use the lock for fastening the cover before carrying the tape reader.
10 Lowering lock lever
When the tape reader is raised, the latch mechanism is activated to fix the tape reader.
Thus, the tape reader is not lowered. The latch is locked with the lowering lock lever.
The latch is therefore not unlocked even when the tape reader is raised with the handle.
When the latch is locked, the lever is horizontal. To store the tape reader in the box,
push the lever to release the lock, then raise the tape reader with the handle to unlock
the latch.
When the latch is unlocked, the tape reader can be stored in the box.
When storing the tape reader, secure it with the cover lock.
11 Cable storage Used to store rolled power and signal cables. The cable length is 1.5 m.
12 Photoamplifier For the tape reader
13
Reader/punch
interface adapter
200 VAC input and 5 VDC output power and reader/punch interface adapter PCB
Procedure for Operating the Portable Tape Reader
1 Unlock the cover locks 9. Raise the tape reader with the handle 6
until it clicks, then lower the tape reader. The tape reader then appears
and is secured. Check that the lowering lock levers
10 are horizontal.
2 Take out the signal and power cables from the cable storage 11 and
connect the signal cable with the CNC reader/punch interface port
and the power cable with the power supply.
3 Turn the control switch to the RELEASE position.
Preparations
Setting the tape

Leave a Reply

Your email address will not be published. Required fields are marked *