FANUC Series 16/18/160/180-Model C Machining Center Operators Manual

INDEX
B–62764EN/01
i–8
Offset/setting screen, 537, 731
Omission of the decimal point, 372
On the memo record, 669
One–digit F code feed, 88
Open command POPEN, 409
Operating motor display, 747
Operating time, 782
Operation after completion of repositioning, 620
Operation during search, 700
Operation error, 384
Operation method, 845
Operation method screen, 847
Operation mode, 742
Operation of portable tape reader, 904
Operation performed when the total depth of cut is reached, 225
Operational devices, 509
Operators, 388
Optional angle chamfering and corner rounding, 231
Optional block skip, 164, 586
Optional stop, 151
Optional stop (M01), 585
Order in which programs are registered, 767
Other setting method, 773
Output file name, 672, 675, 676, 678
Output format, 672, 674, 676, 678
Outputting a program, 668
Outputting a program after file heading, 669
Outputting a program list for a specified group, 687
Outputting custom macro common variable, 678
Outputting offset data, 672
Outputting parameters, 674
Outputting pitch error compensation data, 676
Outputting programs, 684
Overall position display, 740
Overcutting by cutter compensation, 319
Overload torque detection signal, 191
Override, 81, 100, 629
Override condition, 91
Override during thread, 638
Override range, 92, 638
Override value, 93
Overtravel, 645
Overtravel during automatic operation, 645
Overtravel during manual operation, 645
Overview of cutter compensation C (G40 – G42), 283
Ơ
P
ơ
P–type restart, 601
Parameter list, 803
Parameter setting, 745
Parameter setting value (R_), 434
Parameter table, 845, 848
Parameter write, 778
Parameters that require turning off the power, 803
Part count, 745
Partial drawing, 820
Partial enlargement, 823, 828
Partial enlargement drawing, 820
Parts count, 782
Parts count display, run time display, 507
Parts required, 781
Parts total, 781
Password function, 714
Path drawing, 820
Path drawing procedure, 821
Path memorization, 620
Pattern data display, 428
Pattern data input function, 423
Pattern No. selection, 426
Peck drilling cycle (G83), 188
Peck tapping cycle, 217
Peek rigid tapping cycle (G84 or G74), 216
Performing tool length offset along two or more axes, 256
Pitch error compensation, 676
Pitch error compensation data, 675
Plane selection, 123, 233
Plane selection (G17, G18, G19), 54
Plane selection and vector, 287
Plane switching, 233
Plane view (XY,YZ,ZY,XZ), 824
Plane view graphics, 829
Plunge grinding cycle (G75), 220
Polar coordinate command (G15, G16), 126
Polar coordinate interpolation (G12.1, G13.1), 50
Portable tape reader, 550
Position display in the relative coordinate system, 737
Position display in the work coordinate system, 735
Position display, 611
Position display screen, 728
Position mark, 828
Position screen, 528
Positioning, 55
Positioning (G00), 39, 626
Positioning and auxiliary functions, 452
Positioning plane, 175
Positive/negative cutter compensation value and tool center
path, 281, 286
Power disconnection, 553
Power on, 782

Leave a Reply

Your email address will not be published. Required fields are marked *