DRAW. NO. CUST.
01 01.04.11 First issue.
FS16/18/160/180-MC OPERATOR’S MANUAL
Modification of “Linear interpolation positioning”
This report is applied to following CNCs.
This report is a supplement for a following manual.
FANUC Series 16/18/160/180-MC
In the above-mentioned manuals,
the explanation of “4.1 POSITIONING (G00) Linear interpolation positioning” is modified.
The explanation of “4.1 POSITIONING (G00) Linear interpolation positioning” is replaced with
4.1 POSITIONING (G00)
Linear interpolation positioning
The tool is positioned within the shortest possible time at a
speed that is not more than the rapid traverse rate for each
axis. However, the tool path is not the same as in linear