Fanuc Symbol CAPi T Operators Manual

PROGRAMMING AND
OPERATION BY Symbolic FAPT
B–63304EN/02
3. EXECUTION OF
Symbolic FAPT
82
In response to the PC = j prompt, key in ± (INPUT). PC2 is selected.
(³: Right, ²: Left, °: Up, ±: Down)
Figure element 2) DX = jjj R=70
Z = jjj CDX = jjj
TL = jj1CZ=jjj
TN = jj1
Figure element 3) DX = 70 R = 15
Z = jjj CDX = 80
TN = jjj CZ = 33
As two end points are possible (PE1 and PE2), the operator must specify
either of them. (See Fig.3.2.8.)
On the screen, calculated end points are automatically scaled and
indicated by graphic cursors.
The system temporarily scales the two end points so that the operator can
easily select one of them. After the operator specifies a desired end point,
the original scale is restored.
Straight line
of X = 70
Fig.3.2.8 Selecting an End Point
In response to the PE = j prompt, key in ² (INPUT). PE1 is selected.
(³: Right, ²: Left, °: Up, ±: Down)
After all the above data is specified, the arc is defined and the part figure
is drawn on the screen.

Leave a Reply

Your email address will not be published. Required fields are marked *