Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
3. EXECUTION OF
Symbolic FAPT
PROGRAMMING AND
OPERATION BY Symbolic FAPT
83
(2)Notes
NOTE
1 The system can define the center of an arc according to a
given single coordinate when either of the following
conditions is satisfied:
The end point of the previous element is determined.
The next element is known and the arc contacts the
element.
2 The system can define the center of an arc according to a
given single coordinate only when the coordinate (CDX or
CZ) is specified with an absolute value.

Leave a Reply

Your email address will not be published. Required fields are marked *