Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
3. EXECUTION OF
Symbolic FAPT
PROGRAMMING AND
OPERATION BY Symbolic FAPT
85
Following is the configuration which defines the machining process.
Start machining
definition
New definition?
Select a mode
(modify, create, etc.)
Select a process
Is automatic process
determination executed?
No
Yes
Yes
No
Is machining
definition
completed?
No
End
Execute automatic
process determination
Define a tool, machining start
position, and passing point
Specify the cutting
start position
Is grooving, residual machining,
C-axis/Y-axis machining executed?
Outer surface machining, inner surface
machining, grooving, residual machin-
ing, threading, C-axis machining Y-axis
machining
Is there only one
definition point?
Specify the cutting area and the
direction or position of cutting
Define cutting conditions
Is machining of another area
defined with the same tool?
Define cutting
conditions
Yes
Yes
No
No
Yes
Cutting off Center drilling, bar feed
NOTE
The previous screen can be displayed by pressing the [BACK PAGE] key. When a subprocess
is defined, however, the [BACK PAGE] key is disabled.
3.4
MACHINING
DEFINITION

Leave a Reply

Your email address will not be published. Required fields are marked *