Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
3. EXECUTION OF
Symbolic FAPT
PROGRAMMING AND
OPERATION BY Symbolic FAPT
89
Fig. 3.4.1 (c)
[ROUGH O.D.] Press this key for roughing of outer figure. . .
[S–FIN O.D.] Press this key for semifinishing of outer figure. . . . .
[FIN O.D.] Press this key for finishing of outer figure. . . . . . .
[ROUGH I.D.] Press this key for roughing of inner figure. . . .
[S–FIN I.D.] Press this key for semifinishing of inner figure. . . . . .
[FIN I.D.] Press this key for finishing of inner figure. . . . . . . .
[BAR FEED] Press this key for bar feed machining.. . . . .
[SUB CYCLE] Press this key for sub cycle. . . .
Fig. 3.4.1 (d)
[GROOV. NECK] Press this key for grooving (rough grooving. . . . . . .
or rough grooving and finishing are carried
out by a single tool) or necking.
[ROUGH. GROOVE] Press this key for rough grooving. . . .
[FIN. GROOVE] Press this key for grooving finishing. . . . . . . .
[CUT OFF] Press this key for corner cutting (When the. . . . . . . . . . . .
system parameter No.140 is 0, this soft key
is not displayed.)
[THREADING] Press this key for thread cutting. . . . . . . . .
[SUB CYCLE] Press this key for sub cycle. . . . . . . . . .
For example, press Rough O.D. when the soft key in Fig.3.4.1(c) is
displayed; “Roughing of outer figure will have been selected in process
No.1.
NOTE
1 The CUT OFF soft key is not displayed if system parameter
140 is set to 0.
2 For the automatic tool determination function, see Part XI.
For setting the tool data and tooling data, see Part V.

Leave a Reply

Your email address will not be published. Required fields are marked *