Fanuc Symbol CAPi T Operators Manual

PROGRAMMING AND
OPERATION BY Symbolic FAPT
B–63304EN/02
3. EXECUTION OF
Symbolic FAPT
90
Fig. 3.4.2 (a)
When Menu No.4 is selected again after completion of machining
definition, the screen shown above will appear.
[CORR.&OUT] Press this key to correct a selected process and. . .
create the NC data of the corrected process.
[CORRECTION] Press this key to modify or change part of the. .
process.
[NEW] Press this key when reinstructing the process. . . . . . . . . .
from the start after all processes are cancelled.
When “CORRECTION” is depressed, following screen appears.
[+]
[+]
Fig. 3.4.2 (b)
3.4.2
Process Change and
Correction

Leave a Reply

Your email address will not be published. Required fields are marked *