Fanuc Symbol CAPi T Operators Manual

PROGRAMMING AND
OPERATION BY Symbolic FAPT
B–63304EN/02
3. EXECUTION OF
Symbolic FAPT
92
WARNING
After entering tool data, check the entered data. Failure to
enter correct data may result in the tool colliding with the
workpiece and/or machine, possibly causing damage to the
machine and/or tool itself, or injury to the user.
If the working process is specified on the process chart screen, the screen
changes and the tool information required for working definition is
prompted.
Soft keys
ESCAPE Displays the menu screen.. . . . . . . . . . . .
BACK PAGE Displays the previous page.. . . . . . . .
TAB Skips the system inquiry for the tool data. . . . . . . . . . . . . . . .
and displays that for the machining start
position.
NEXT TOOL Selects the ID of the next tool whose. . . . . . . .
machining process type (KP) is specified.
(The automatic process determination
function is required.)
TOOL DATA Displays the tool data list. The data can be. . . . . . . .
specified and corrected.
TOOLING INFOR Displays the tooling information list. . . . .
The data can be specified and corrected.
CURSOR °, CURSOR ± Moves the cursor to a prompt.. . . .
CHECK Draws the tool figure. (The animated. . . . . . . . . . . . .
simulation function is required.)
P.PNT SET Displays the section in which a passing. . . . . . . . . .
point can be specified.
NEXT PAGE Displays the next page.. . . . . . . . .
The system prompts the operator to specify the following tool data:
1 Tool number data
2 Tool figure data
3 Tool setting data
3.4.4
Tool Data

Leave a Reply

Your email address will not be published. Required fields are marked *