Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
3. EXECUTION OF
Symbolic FAPT
PROGRAMMING AND
OPERATION BY Symbolic FAPT
93
(1)Tool number data
The system prompt the user to specify the following:
TURRET NO. TL = J. . . . . . . . . . .
TOOL SELECT NO. TN = J J. . . . . .
TOOL OFFSET NO. TM = J J. . . . .
TOOL OFFSET NO.2 TM2 = J J. . . .
TOOL ID NO. ID = J J. . . . . . . . . . .
TURRET NO. TL = Turret number. . . . . . . . . .
The system prompts the operator to specify a turret number if the
machine has two or more turrets.
Specify the number of turrets in the following MTF:
No.1050: Number of turrets (1 or 2)
1: Two–axis lathe (one turret)
2: four–axis lathe (one spindle/two turrets)
TOOL SELECT NO. TN = Tool selection number. . . . . . .
To use a tool whose tooling data is registered, enter the corresponding
tool selection number.The other data is then automatically displayed.
To enter a tool selection number greater than 99, modify the following
MTF. An integer of up to 654 can be specified.
The maximum tool number usable in menu No. 6 (animated
simulation) is 255.
No.1104: Number of digits of the Tcode tool selection number (up to 3)
TOOL OFFSET NO. TM = Tool offset number. . . . . . .
To enter a tool offset number greater than 99, modify the following
MTF. An integer of up to 654 can be specified.
No.1105: Number of digits of the Tcode tool offset number (up to 3)
A tool offset number can be specified for each cutting area. To perform
individual tool offset for each of the specified cutting areas, specify the
value for switching the offset numbers in the following system parameter:
No.704: 0 0 0 0 0 0 0 0
For each cutting area, the T code specifying tool
offset is:
= 0: Not output.
= 1: output.
If the parameter is set to a value for outputting the T code specifying tool
offset for each cutting area, this prompt is made when the cutting
condition data is entered. (For details, see Section 3.4.8.)
TOOL OFFSET NO.2: TM2 = Specifies the tool offset number for the
minor cutting edge of a grooving tool.
If a grooving tool is used, a tool offset number can be specified for the
minor cutting edge. To specify the tool offset number for the minor
cutting edge, set the following system parameter (Warning):
No.704: 0 0 0 0 0 0 0 0
Before cutting with the minor cutting edge is started in
grooving, the T code of the secondary tool offset is:
= 0: Not output.
= 1: output.

Leave a Reply

Your email address will not be published. Required fields are marked *