OPERATION BY Symbolic FAPT
3. EXECUTION OF
TOOL ID NO. ID = Tool identification number. . . . .
When a tool identification number is entered, the registered tool figure
data and tool setting data are displayed.
To use a tool whose tool data is not registered, do not define the tool
If the entered tool identification number is not registered, the NOT
FOUND TOOL ID. NO. message is displayed.
If the tool type corresponding to the selected tool identification
number is not suitable for the current process, the TOOL TYPE
DON’T FIT THIS PROCESS message is displayed.
If TOOL OFFSET NO.2 is specified, the T code of the
secondary tool offset number is output before the minor
cutting edge is moved for grooving.
TOOL SELECT NO. = 01
TOOL OFFSET NO. = 01
TOOL OFFSET NO.2 = 02