Fanuc Symbol CAPi T Operators Manual

PROGRAMMING AND
OPERATION BY Symbolic FAPT
B–63304EN/02
3. EXECUTION OF
Symbolic FAPT
96
NOTE
The system can be set so that it displays the tool figure data
and does not allow modification. To do this, change the
following system parameter:
No.702: 0 0 0 0 1 0 0 0
Specifies whether the tool figure data can be
specified in machining definition.
= 0: Cannot be specified. (The data is just displayed.)
= 1: Can be specified.
(3)Tool setting data
[Setting data of a turning tool]
SETTING ANGLE AS =JJJJ. JJJ. . . . . . .
SETTING POSITION XS =JJJJ. JJJ. . . . .
ZS =JJJJ. JJJ
SPINDLE DIRECTION SD =J. . .
HOLDER NO. HL =JJ. . . . . . . . . . .
SETTING ANGLE AS = Setting angle. . . . . . . .
Enter the setting angle according to the drawing format. This line is
not displayed when a center drill, drill, or finger bit is selected.
SETTING POSITION XS = Setting position along the X–axis,. . . . . .
ZS = Setting position along the Z–axis
SPINDLE DIRECTION SD = Direction of spindle rotation. . . .
0: Clockwise
1: Counterclockwise
The following system parameter specifies whether the spindle
direction can be specified for each tool:
No.702: 0 0 0 0 0 0 0 0
Specifies whether the spindle direction can be
specified for each tool.
= 0: Cannot be specified.
= 1: Can be specified.
HOLDER NO. HL = Holder number for animated simulation. . . .
The system prompts the operator to enter the holder number if the
animated simulation function is provided. If the specified holder is not
defined, it is not drawn.
* Warning and Note on tool data
WARNING
After the NC data is created, the tool data is first checked to
see whether the figure is creates causes interference and
then the offset data is calculated. The output NC data is
correct only when the entered tool data is correct.

Leave a Reply

Your email address will not be published. Required fields are marked *