Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
3. EXECUTION OF
Symbolic FAPT
PROGRAMMING AND
OPERATION BY Symbolic FAPT
97
NOTE
If the NEXT PAGE soft key is pressed to display the next
screen when a tool with registered tool data is selected, the
set data is registered as the tooling data.
For milling tools, see Chapter VIII.
(4)When the machine has two turrets (TT model)
When the machine has two turrets, a change in the turret number
inverts the drawing of the tool figure.
Example of tool figures displayed when tools having
an identical figure on different turrets are changed
NOTE
1 If the tool holder is not defined, only the tip is displayed.
2 The scale of the tip and holder cannot be changed.
WARNING
After entering machining start point data, check the entered
data. Failure to enter correct data may result in the tool
colliding with the workpiece and/or machine, or forced
machining occurring, possibly causing damage to the
machine and/or tool itself, or injury to the user.
When all tool data is entered, the system prompts the operator to enter the
data of the machining start position.
MACHINING START POSITION:
DXO = JJJJ. JJJ ZO = JJJJ. JJJ
DXO = X coordinate of the machining start position
ZO = Z coordinate of the machining start position
The machining start position can be automatically determined according
to the turret turning position and tool setting position.
DXO = DXI (turret turning position) XS (setting position) 2
ZO = ZI (turret turning position) ZS (setting position)
3.4.5
Machining Start
Position

Leave a Reply

Your email address will not be published. Required fields are marked *