Fanuc Symbol CAPi T Operators Manual

PROGRAMMING AND
OPERATION BY Symbolic FAPT
B–63304EN/02
3. EXECUTION OF
Symbolic FAPT
98
The following system parameter specifies whether the operator is
prompted to enter the machining start position:
No.009: 0 0 0 0 0 x 0 0
Specifies whether the operator is prompted to
enter the machining start position.
= 0: Prompted.
= 1: Not prompted.
WARNING
After entering passing point data, check the entered data.
Failure to enter correct data may result in the tool colliding
with the workpiece and/or machine, or forced machining
occurring, possibly causing damage to the machine and/or
tool itself, or injury to the user.
(1)This function designates the passing point of a tool when approaching
to the work from the machining start position, and the passing point
of a tool when returning to the next machining start position after
completion of the machining.
When the rightmost soft key [
³
³
] is pressed on the tool data screen, the
following soft keys are displayed:
When the P.PNT SET soft key is pressed, the system prompts the operator
to enter the data of the passing point.
Fig. 3.4.6 (a)
3.4.6
Passing Point

Leave a Reply

Your email address will not be published. Required fields are marked *