Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
3. EXECUTION OF
Symbolic FAPT
PROGRAMMING AND
OPERATION BY Symbolic FAPT
99
PASSING POINT FOR APPROACH:
1’ST POINT XA1 =. . . . . . . . . . . . . . . .
ZA1 =
2’ND POINT XA2 =. . . . . . . . . . . . . . . .
ZA2 =
Designate the passing point of tool when approaching to the work from
the machining start position at the time of machining start.
PASSING POINT FOR ESCAPE:
1’ST POINT XE1 =. . . . . . . . . . . . . . . .
ZE1 =
2’ND POINT XE2 =. . . . . . . . . . . . . . . .
ZE2 =
Designate the passing point of tool when escaping from the work up to
the next machining start position upon completion of machining.
WARNING
The following system parameter specifies whether the
operator is prompted to enter a passing point for each
machining type:
Nos.105 to 115, 300 to 305: x 0 0 0 0 0 0 0
Specifies whether the operator is
prompted to enter a passing point for
each machining type.
= 0: Not prompted.
= 1: Prompted.
When no data is defined, the axis in question does not move.
For example, in the absence of input on Zaxis coordinate value after
inputting some data to Xaxis coordinate value, the tool moves to the
specified position only for Xaxis, and Zaxis does not move.
Fig. 3.4.6 (b) Designation pf passing point

Leave a Reply

Your email address will not be published. Required fields are marked *