Fanuc Symbol CAPi T Operators Manual

PROGRAMMING AND
OPERATION BY Symbolic FAPT
B–63304EN/02
3. EXECUTION OF
Symbolic FAPT
100
Set the number of simultaneous moving axes in a motion from the
machining start position to (XA1, ZA1) and the number of simultaneous
moving axes in a motion from (XE2, ZE2) to the next machining start
position using the following system parameters.
[Turning]
Nos.105 to 115: 0 0 0 x x 0 0 0
Specifies the number of axes along which the
tool approaches simultaneously.
Specifies the number of axes along which the
tool retracts simultaneously.
= 0: Two axes
= 1: One axis
[C–axis machining]
Nos.300 to 305: 0 0 x x x
0 0 0
Specifies the number of axes along which the
tool approaches simultaneously.
= 00: One axis
= 01: Two axes
= 10 or 11: Three axes
Specifies the number of axes along which the
tool retracts simultaneously.
(Z–axis and X–axis)
= 0: Two axes
= 1: One axis
(1)Outer surface machining and inner surface machining
The following soft keys are displayed when the operator is prompted to
specify a dividing direction:
3.4.7
Specifying the
Direction and Area of
Cutting

Leave a Reply

Your email address will not be published. Required fields are marked *