Fanuc Symbol CAPi T Operators Manual

PROGRAMMING AND
OPERATION BY Symbolic FAPT
B–63304EN/02
3. EXECUTION OF
Symbolic FAPT
102
To select the start or end point, move the cursor along the part figure.
Each time the CURSOR FORWRD or CURSOR BACK key is
pressed, the cursor moves forward or backward along the part figure.
After entering the start and end points, specify a cutting area by
pressing arrow keys corresponding to desired dividing directions in
the blank figure.
Specify the following directions by pressing the corresponding arrow
keys:
DIVIDING DIRECTION Dividing direction from the start point. . . . . . . . . .
DIVIDING DIRECTION Dividing direction from the end point. . . . . . . . . .
Any one of the following eight directions can be selected:
[°] [±] [³] [²] [¾] [¼] [½] [¿]
3) Sample divisions
When an arrow key is pressed, an imaginary line is drawn from the
position of the blinking cursor in the direction of the arrow. The
cutting area is an area enclosed with the imaginary lines drawn by the
arrow keys and the lines of blank figure and part figure (shaded area
in figures below).

Leave a Reply

Your email address will not be published. Required fields are marked *