Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
3. EXECUTION OF
Symbolic FAPT
PROGRAMMING AND
OPERATION BY Symbolic FAPT
103
The cutting area can be displayed on this screen so that the operator
can check the area specified by entering the dividing directions. Set
the following system parameters so that the cutting area can be
displayed:
No.670: Color in which the blank figure is filled in on the machining definition
screen
No.671: Color in which the cutting area is displayed on the machining
definition screen
No.704: x x 0 0 0 0 0 0
Specifies whether the cutting area is displayed on the
machining definition screen.
Specifies whether the blank figure is filled in on the machining
definition screen.
The figure of the workpiece is still displayed on the screen after the
specified area is cut off. Symbolic FAPT simulates all stages of
machining on the screen. The operator can easily check whether the
area to be cut remains.
The shape of the tool determines the area it can cut. The system
automatically checks the relationship between the tool shape and part
figure and displays the area which the tool cannot cut. Specify another
tool to cut the uncut area.

Leave a Reply

Your email address will not be published. Required fields are marked *