Fanuc Symbol CAPi T Operators Manual

PROGRAMMING AND
OPERATION BY Symbolic FAPT
B–63304EN/02
3. EXECUTION OF
Symbolic FAPT
104
4) Specifying cutting of the remaining area
The above figure shows an example of an uncut area that results
because of the relationship between the part figure and tool shape. To
cut the uncut area, specify a tool having an inverted tool tip.
If an attempt is made to specify cutting of the uncut area with a tool
having the wrong tip or wrong figure data, the system may not accept
the area data.
Once the area has been specified, the screen for specifying the cutting
conditions for that area is displayed.

Leave a Reply

Your email address will not be published. Required fields are marked *