Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
3. EXECUTION OF
Symbolic FAPT
PROGRAMMING AND
OPERATION BY Symbolic FAPT
105
(2)Cutting off
Specify the start point of cutting off by pressing the CURSOR
FORWRD or CURSOR BACK soft key.
The tool path for cutting off is illustrated below.
Fig. 3.4.7 (a)
If the cursor is moved to specify the previous figure element as the start
point, the tool path becomes as shown in Fig. 3.4.7 (b).

Leave a Reply

Your email address will not be published. Required fields are marked *