Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
3. EXECUTION OF
Symbolic FAPT
PROGRAMMING AND
OPERATION BY Symbolic FAPT
109
WARNING
The cutting conditions are automatically set according to the
selected machining type. Check the set conditions. If the
conditions are incorrect, the tool may collide with the
workpiece and/or machine, or forced machining may occur,
possibly causing damage to the machine and/or tool itself,
or injury to the user.
Input the data of CUTTING CONDITION.
(Example : ROUGHING OF OUTER FIGURE)
The cutting conditions are automatically set and displayed according to
the kinds of selected materials. Change only the desired items, while
monitoring the CRT screen. To display the next page, press the NEXT
PAGE soft key. To use the tool to cut another area, display the area
definition screen. Unless the tool is used to cut another area, display the
tool list screen.
If you want to change the feedrate to 75% of the displayed value, for
example, multiply the displayed value by 0.75 as follows.
(Example) F1 =
3
*
0
.
7
5
INPUT
* Outputting the T code specifying the tool offset for each cutting area
The T code of the tool offset number, output for each process, can be
output for each of the specified cutting areas.
3.4.9
Cutting Conditions

Leave a Reply

Your email address will not be published. Required fields are marked *